Loading this version…
No owner reports yet. This is not a recommendation to install or to wait. At least 5 reports on this site are required before votes can say Safe, Mixed, or Hold off.
0 fine · 0 problem · 0 on this site · need 5 before votes set the badge on their own
RFID, farm networking, and a Russian UI. The same entry lists two leftover gaps around Handy and E3D hotends.
Bambu Handy can install an older package while Bambu still hosts it. Do not cut power during the flash. Official notes for 01.10.00.00 say a printer below 01.09.01.00 has to take an offline hop through 01.09.01.00 before any newer build. After a rollback, run motor-noise or flow calibration again if the version you left asked for it.
Tell the next P1S owner whether 01.09.00.00 was fine, or what broke. This is stored with the site, not sent to Bambu.
One report per printer is the idea. There is no account, so we cannot stop a second submission. If a later print changes your mind, send another and say so in the note.
A report is one owner's opinion, not a Bambu Lab finding. Skip spam and abuse — we may remove junk.
No owner reports yet. The badge above is not a community vote. If you already installed this version, add whether it printed fine.