Loading this version…
Mixed is set by an editor note in the data file. There are 0 owner reports on this site, which is under 5, so votes do not replace that note.
0 fine · 0 problem · 0 on this site · need 5 before votes set the badge on their own
Editor note in the data file
This Mixed badge is an editor note, not a 3DP Firmware poll. The P2S wiki entry for 01.03.00.00 (dated 21 Sep 2026 in the page contents) says known issues: none. Separately, a Bambu Lab forum thread opened 30 Sep 2026 describes first layers that went too thin or scraped after this update, including on a 0.2 mm nozzle. Several posters wrote that downgrading to 01.02.00.00 and recalibrating fixed it on their machines. This site has not reproduced that, and those forum posts are not counted as owner reports here.
E3D high-flow hotend support, Z-axis motor noise cancellation, and faster travel. Bambu's notes say there are no known issues. A forum thread describes nozzles that ended up too close to the bed.
Bambu's notes for this version explicitly say there are no known issues. That is their list at the time we read it. It is not a count of owner reports.
Handy is the usual way to install an older package Bambu still hosts. A Bambu forum thread about 01.03.00.00 includes owners who said rolling back to 01.02.00.00 and recalibrating restored a normal first layer. That is their report, not a test run on this site, and those posts are not counted in the report totals here. If a release note says motor noise cancellation changed, run that calibration again after you move.
Tell the next P2S owner whether 01.03.00.00 was fine, or what broke. This is stored with the site, not sent to Bambu.
One report per printer is the idea. There is no account, so we cannot stop a second submission. If a later print changes your mind, send another and say so in the note.
A report is one owner's opinion, not a Bambu Lab finding. Skip spam and abuse — we may remove junk.
No owner reports yet. The badge above is not a community vote. If you already installed this version, add whether it printed fine.